Why maintenance matters
A well-maintained machine gives accurate cuts, a steady impression and fewer stoppages. Small daily checks cost very little compared with the loss from a sudden breakdown.
7 simple maintenance tips
- Clean daily: Remove paper dust, foil scraps and debris from the platen and bed after every shift.
- Lubricate moving parts: Follow the oiling schedule for bearings, guides and joints.
- Check platen alignment: Make sure the pressure stays even so cuts and foil impressions stay sharp.
- Inspect heating elements: On hot foil machines, confirm that the temperature control is accurate and the heating plate warms evenly.
- Tighten fasteners: Continuous vibration can loosen nuts and bolts over time.
- Check electrical connections: Look for worn wires, loose terminals and faulty switches.
- Keep safety guards in place: Never run the machine with guards removed, and train every operator.
Keep a simple log
Note the date of cleaning, oiling and any repair. A basic maintenance log helps you plan spare parts and spot problems early.
If you face a problem you cannot fix, contact the manufacturer for guidance rather than running the machine under stress.